MORTERPLAS SBS FPV MIN 5KG: it is a self-protected waterproofing membrane, made of SBS elastomeric bitumen, reinforced with reinforced and stabilized polyester felt (FP), and finished with a mineral protection on the upper side and a thermally bonded film on the lower side.
Guaranteed for 20 years when used as two layer system with SBS FV 3kg underlay.
- The stabilized, non-woven polyester felt (FP) reinforcement,
- confers the best mechanical properties to the membrane:
- High tensile strength
- Maximum puncturing resistance (static and dynamic)
- High tear resistance
- Good dimensional stability.
- The SBS elastomeric mastic provides the membrane with excellent flexibility at low temperatures, which allows it to be applied in cold climates
- It is especially recommended in applications where maximum puncturing resistance and maximum mechanical output are needed.
- MORTERPLAS SBS FPV MIN Finishing membrane in multi-layer systems for non-trafficable roofs
- MORTERPLAS SBS FPV MIN as a finishing membrane in mechanically fastened double-layer membranes, in accordance with DIT No. 06/0018
- For single-layer systems, the MORTERPLAS FPV 5kg MIN membrane with a mass ≥ 5 kg/m² will be used in systems in accordance with the DITs and local construction regulations
- SUPPORT: The surface must be dry, firm, even, clean and free of loose materials.
- It can be applied completely adhered, partially adhered or floating.
- To adhere the membrane to the support, the support is primed with EMUFAL I. Once dry, use flame to adhere the membrane.
- The flame is applied as uniformly as possible (the greater the heat, the greater the retraction) along the width of the membrane without reaching the overlap, which will be done later, since it is important that the temperature be the same in every area. The flame should be applied until the antiadherent film pore opens.
- The membranes are installed in such a way that no more than three membranes overlap at the same point.
- Overlaps are flame-bonded, with a longitudinal overlap of at least 8 cm and a transversal overlap of at least 10 cm, first removing the minerals from the surface to ensure adherence.
- In the two-layer solution, the top membrane must be completely adhered to the bottom membrane, and it must be placed in the same direction so that the overlap lays approximately in the middle of the bottom membrane.
- Installation and measurements will be conducted in accordance with regulations of the UNE 104401 standard
- In accordance with the EN 13707 standard. Certified with CE marking No. 0099/CPD/A85/0087
- Voluntary certification of the product with AENOR seal according to the same European standard.
- With DIT No. 06/0018 MORTERPLAS SBS FM DOUBLE-LAYER
- Quality System in accordance with ISO:9001